PDA

View Full Version : Frick 283 load/unload pots







RANGER1
31-12-2014, 07:14 AM
Could anyone please assist with information of load pots on a TDSH 283L.
Do they have a partcular order to load/unload.
This one has 3 solenoids. ie no slide valve
Thanks

Grizzly
31-12-2014, 09:48 AM
Hi Ranger.
I may have some info somewhere (Historic) I will have a look!
Grizzly

RANGER1
31-12-2014, 08:37 PM
Thanks Grizzly

HVACRsaurus
01-01-2015, 01:43 AM
http://www.genemco.com/catalog/pdf/ASAC002FrickRWBCompressorParts.pdf

Page 92, Figure 38?

I've not seen a Frick with "Port Style" loading, always the typical slide valve arrangement..

Cloud it be regular slide valve just with trick solenoids?

Happy new year.

RANGER1
01-01-2015, 04:10 AM
http://www.genemco.com/catalog/pdf/ASAC002FrickRWBCompressorParts.pdf

Page 92, Figure 38?

I've not seen a Frick with "Port Style" loading, always the typical slide valve arrangement..


Cloud it be regular slide valve just with trick solenoids?

Happy new year.


Thanks, has no unload cylinder, as blanked off.
3 pots underneath rotor housing for 50,75, 100% with 3 , 3 way solenoids.
Would just like to know order to load/unload, if it matters or not.

HVACRsaurus
01-01-2015, 05:42 AM
Thanks, has no unload cylinder, as blanked off.
3 pots underneath rotor housing for 50,75, 100% with 3 , 3 way solenoids.
Would just like to know order to load/unload, if it matters or not.

Interesting, I haven't seen one like that, must look a sight - cat with its tail chopped off perhaps..

RANGER1
01-01-2015, 07:34 AM
My fault it's TDSL 283 Frick

RANGER1
01-01-2015, 08:30 AM
HVACRsaurus,
Sent you a PM for interest on this model.

kiwi
22-03-2015, 08:33 AM
Find what you needed? Its definitely a TDSL. Im pretty sure they are linear and go something like 50%-75%-100% from NDE to DE. been a long tie since I last looked at one of these.

cricri
27-03-2015, 06:37 AM
12663Hi Ranger,
I took the opportunity of the overhaul of a TDSL283 in our workshop to take some pictures of the pots. So you'll understand how it works. if something isn't clear, the compressor is still open!

RANGER1
27-03-2015, 09:37 AM
Thanks cricri,
So how many load pots are there underneath machine?
The one I was working on had 3.
Pictures look like 3 pots on each side (male/ female rotor).

RANGER1
27-03-2015, 09:43 AM
Thanks cricri,
So how many load pots are there underneath machine?
The one I was working on had 3.
Pictures look like 3 pots on each side (male/ female rotor). also very slow to load & unload, probably due to small oil gallery or orifice so they don't smash themselves to pieces!

cricri
27-03-2015, 11:55 AM
there are 3x2 potsunderneath. operating conditions -46C/-14C;NH3

weagle
27-03-2015, 12:55 PM
Gardner Denver had a similar way of capacity control with there turn valve. Interesting conversation guys. Thanks for the info.