PDA

View Full Version : Not receiving remote signal - older Fujitsu model split system



CapnBloodbeard
22-10-2014, 10:30 AM
Hi All,

Not sure if anybody can help. I have an older model split system A/C in my loungeroom - Fujitsu AST24RGB-W. There's absolutely no response from the remote control.

The remote is still putting out a signal (pointed it at my digital camera), but there's no response from the A/C. I figured the IR receiver had died, so I pulled out the IR board and saw a blown capacitor. I replaced it, but it still doesn't work.

So, either my repair job was terrible (I haven't soldered anything in about 15 years, so it wasn't a great job, but I can't see any crossed circuits from the solder), or something else is at fault.

Any ideas? I can't locate a replacement board online unfortunately - looks like they don't make parts for this model, and I'd rather not replace it if I can repair it.

frank
22-10-2014, 08:28 PM
Sounds like you need replacement parts, these people can help you

http://spares.bigwarehouse.com.au/index.php?cPath=114_62396_86168&osCsid=964328f5bcd86e8780e5a1e30683f13b

CapnBloodbeard
23-10-2014, 12:04 AM
Thanks, I've had a look on there and it says the IR Receiver board is no longer available.

Airsteve
23-10-2014, 09:20 AM
Try these guys, i have used them before when parts are no longer available. Send in your remote and receiver.
http://www.modulerepair.com.au/

nike123
24-10-2014, 04:50 PM
Any TV repar shop could do that repair in 15 seconds!