PDA

View Full Version : Danfoss ak-st 500 servicetool







NEugeny
20-10-2014, 03:47 PM
I'm need a software for change parameters of controller AK-PC 781.
This software called "AK-ST 500 SERVICE TOOL".
Or, where can I find it?

Glenn Moore
20-10-2014, 06:07 PM
Hi NEugeny
You have to purchase the ST 500 software from Danfoss, you can download any updates for free from the Danfoss website. You also need a PC USB to RJ45 connector cable to enable you to connect to the controller
Code no for the ST 500 software 080Z0161 and for the cable connector (PC to RJ ) 080Z0262

NEugeny
21-10-2014, 12:29 AM
Thanks for the answer, but I'm running out time. I can't wait until the buy program.
Through adapkool I can't nothing change.

Glenn Moore
21-10-2014, 08:24 PM
If you have an AKA245 LON gateway you can connect via the LON connections to change parameters but you need the ST 500 to change the controller set up

NEugeny
22-10-2014, 03:21 PM
If you have an AKA245 LON gateway you can connect via the LON connections to change parameters but you need the ST 500 to change the controller set up

Thank you for such advice. I never would have thought possible through LON interface change of controller parameters.
But there were good people, given the program AK-ST, and saved me.
;-)