darrellpope
15-07-2014, 09:07 PM
i need help with a fridge freezer model number beko ap930x.
it had a E8 fault which was the ice maker sensor which as been changed and is fine it now as a problem showing E0 which is freezer thermistor.
the fridge as been unplugged for a few weeks while having work done now it wont get to tempature and shows a E0 error.
i have monitored the fridge running cycle and found the compressor only runs for a maxium of 60 seconds some times only about 10 seconds ? compressor gets warm over time but not hot as you would expect as its got a lot of work to do , i have check the condenser fan motor and that runs when the compressor runs and the internal fans run ok and compressor seems pretty quiet.
so because the compressor cycle is so short i assume thats the reason im not getting to tempature.
i have read on other forums if the freezer thermistor goes faulty normally the freezer will run non stop is this correct ? and would a E0 fault stop the compressor running as the fridge still needs to be cooled.
is there any checks i can do
it had a E8 fault which was the ice maker sensor which as been changed and is fine it now as a problem showing E0 which is freezer thermistor.
the fridge as been unplugged for a few weeks while having work done now it wont get to tempature and shows a E0 error.
i have monitored the fridge running cycle and found the compressor only runs for a maxium of 60 seconds some times only about 10 seconds ? compressor gets warm over time but not hot as you would expect as its got a lot of work to do , i have check the condenser fan motor and that runs when the compressor runs and the internal fans run ok and compressor seems pretty quiet.
so because the compressor cycle is so short i assume thats the reason im not getting to tempature.
i have read on other forums if the freezer thermistor goes faulty normally the freezer will run non stop is this correct ? and would a E0 fault stop the compressor running as the fridge still needs to be cooled.
is there any checks i can do