Damian35
20-04-2014, 11:36 AM
Hi,
I don't know if anyone can help me.
It is a long story but I am installing the pipe work and installation for a Mitsubishi inverter at my house, with the final connections and commissioning by a local installer.
When inserting a 90 deg bend in the 3/8 gas line, I've managed to kink the pipe by 1 to 2mm which can hopefully be seen by the included photos. I know what went wrong, frustrating after several perfect practices with the pipe bender. It needs to be right and I'll go and buy another 15m of copper as soon as possible if necessary but just wanted confirmation that I need to start again with this.
I know I should have got someone to do the job for me but it would need a couple of visits given the other work what is going on, so like an idiot thought I would try and do it myself. Obviously gutted, especially as I wanted to get all the pipe work in this far on.
Any thoughts much appreciated.
Many thanks,
Damian
1142511426
I don't know if anyone can help me.
It is a long story but I am installing the pipe work and installation for a Mitsubishi inverter at my house, with the final connections and commissioning by a local installer.
When inserting a 90 deg bend in the 3/8 gas line, I've managed to kink the pipe by 1 to 2mm which can hopefully be seen by the included photos. I know what went wrong, frustrating after several perfect practices with the pipe bender. It needs to be right and I'll go and buy another 15m of copper as soon as possible if necessary but just wanted confirmation that I need to start again with this.
I know I should have got someone to do the job for me but it would need a couple of visits given the other work what is going on, so like an idiot thought I would try and do it myself. Obviously gutted, especially as I wanted to get all the pipe work in this far on.
Any thoughts much appreciated.
Many thanks,
Damian
1142511426