PDA

View Full Version : Toshiba RAV Fault relays



licencetochill
28-03-2014, 01:15 AM
hi guys,

Iv'e to install a load of Toshiba Rav series units, wall munts,ceiling mounts etc.
They need a fault relay on each one.
Any of you know if they would have a fault output ?
or an idea as to go about this?


regards

marc5180
28-03-2014, 09:34 AM
hi guys,

Iv'e to install a load of Toshiba Rav series units, wall munts,ceiling mounts etc.
They need a fault relay on each one.
Any of you know if they would have a fault output ?
or an idea as to go about this?


regards

Hi,
You can use a Fault indication module which connects to indoor PCB

Model number RBC-FDP2-PE

http://www.realtime-controls.co.uk/products/9670-0%20FDP2-BMS%20Installation%20Instructions%20v1.14.06.pdf