View Full Version : York Wiring Diagrams
iceman007
05-03-2006, 12:02 PM
Would anyone happen to know where I can get a wiring diagram for a York Chiller (Millenium Screw with intelligent controller). Customer has got nothing and can't find anything on the chiller itself. I have been getting a Low curr/MP/HP fault and think I might need to go through the start circuit aux contacts etc. York are not being too forthcoming with any info, as I have been trying to get some service manuals as well.
Thanks
rbartlett
05-03-2006, 12:39 PM
have you tried york.com?
cheers
richard
Josip
05-03-2006, 12:59 PM
Helo, try this:
https://www.refparts.york.com/ALLParts/Webpages/SearchDocumentation.aspx?CompId=982
Airclima
05-03-2006, 02:40 PM
http://www.york.com/products/esg/ServiceLit/ServiceSplash.asp#
Iceman
Whats the model, i think i have some wiring diagrams somewhere, even as a york employee wiring diagrams were a bugger to get!!
Al
iceman007
05-03-2006, 08:35 PM
Al,
I've sent you a private message, with as much information as I have on there.
I've been on all the York websites etc. Tried to get some assistance from York-I don't think theres a humour section on here!!!!!. I give up-almost.
Thanks to all for their input.
James
Snowman123
05-03-2006, 09:12 PM
Its normal for the auxilary contacts to play up on the top of the contactor if you have Abb type contactors. Or its the hp switch. If the compressor runs in star then trips its the auxilary contacts, if nothing runs its the hp switch. Good luck.:)
iceman007
05-03-2006, 11:06 PM
I'll reset it in the morning and see what happens.
Thanks alot.
iceman007
06-03-2006, 06:56 PM
Reset the chiller this afternoon, and managed to run it up eventually. The contacts are OK and the HP OK, I have put it down to a suspected refrigerant leak.
Al I've sent you a seperate message.
Thanks
nicolaas
06-04-2010, 05:23 PM
Veru interesting reading the faults and problems shared and the good response and help given by all. keep it up. I like the quote: give 100% at work. Cool! Thanks for the respons on my question
Nico
goshen
09-04-2010, 02:49 PM
Veru interesting reading the faults and problems shared and the good response and help given by all. keep it up. I like the quote: give 100% at work. Cool! Thanks for the respons on my question
Nico
Hi if u want i have ycas complete user manual and will be happy to pass it on:)
mohamadreza
09-04-2010, 07:05 PM
hi goshen
would you please send me the user manul of unisab lll or electronic diagram?
thanks a lot
nicolaas
10-04-2010, 04:57 PM
Thank you very much that will be much appreciated.
Thanks.
Nico.
nicolaas
10-04-2010, 05:03 PM
Thanks for offering me the ycas complete user manual Goshen I'll appreciate it a lot.
Thanks.
Nico.
goshen
10-04-2010, 06:48 PM
hi goshen
would you please send me the user manul of unisab lll or electronic diagram?
thanks a lot
hi mail me at gill@gosheneng.co.il (gill@gosheneng.co.il):D
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.