NorthSeaTech
30-08-2013, 04:51 PM
Hi All,
We have a bit of an issue with a Carlyle 5H86.
The system was orginally on R22 and decision was made to convert to R417A.
This change out was not completed by myself, i am merely trying to assist in the troubleshooting of the system.
Since the changeout has been completed the system was ran and displayed extreme vibrations so much so that the tech shut it down. CBM readings showed 119 mm/s from the unit.
The unit is also performing poorly i have attached a rough sketch containg temps etc for reference - http://www33.zippyshare.com/v/2647369/file.html.
Any recommendations?
We have a bit of an issue with a Carlyle 5H86.
The system was orginally on R22 and decision was made to convert to R417A.
This change out was not completed by myself, i am merely trying to assist in the troubleshooting of the system.
Since the changeout has been completed the system was ran and displayed extreme vibrations so much so that the tech shut it down. CBM readings showed 119 mm/s from the unit.
The unit is also performing poorly i have attached a rough sketch containg temps etc for reference - http://www33.zippyshare.com/v/2647369/file.html.
Any recommendations?