From Tekelek dial thermostat to programmable thermostat, how?

[kurisu]

Hi there,

I've got a Tekelek 425 dial thermostat (low voltage) connecting to a Brivis Advance 44 evaporative cooler, and hope to switch to thermostat with terminals R, Y, G....etc.

There are 4 wires going from the evaporative cooler to the current thermostat, as shown in http://i.imgur.com/ceBUMdw.jpg

Blue wire connects to terminal named "0V"
Green wire connects to terminal named "Control 2"
Yellow wire connects to terminal named "Control 1"
Red wire connects to terminal named "5.6V"

Does anyone knows how these translate to terminals R/Y/G..etc?

Thanks

[install monkey]

y cooling signal
g fan
w heat
r power into controller

[kurisu]

How the four colors of the above mentioned wires fit?

[install monkey]

dont know- u need to check on the cooler for what colour wire connects to what terminal
found an install manual it its any help
click on the link below
http://www.mediafire.com/download/pq86ww6987tau8o/Brivis_Heating_Installers_Manual.pdf