View Full Version : Grasso screw
Magoo
20-07-2013, 01:45 AM
Does anyone have info on wegsensor sw25, slide position feed back pot.
Grizzly
20-07-2013, 09:19 AM
Hi My Friend!
I will check what else I have, but in the meantime perhaps the attached may help?
How old roughly is the comp?
Do you know the actual model details?
http://www.mediafire.com/?hpi64kr3c8tdquw
http://www.mediafire.com/?t0c75jy0pvbv8nr
http://www.mediafire.com/?0dcs08pjgk405qw
Some of this is a bit basic and I can see your dillema.
Where there is little or none electrical info.
Hopefully someone can help further.
Steve
HVACRsaurus
20-07-2013, 01:01 PM
Hi Magoo,
The grass screw compressor documation shows calibration procudure for the position transmitter - they are as finiky as hell. The new item is a retrofit, and it's finiky too..
I have information on both.
Magoo
20-07-2013, 11:26 PM
Hi Grizzly and HVACR. thanks for replies and information. Compressor is a close coupled G3 approx. 12 years old. Twin compressor set up. AB/ PLC control.
PaulZ
12-08-2013, 04:53 AM
Hi Magoo
Not sure if this is what you are after.
http://www.sendspace.com/file/ewh130
Rehards
Paul
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.