View Full Version : euro frigo control
cadwaladr
31-05-2013, 11:05 PM
got yet another one of these ,this one has had the plug/wiring damaged that goes to the controller the plug is no longer on the cable,can this plug be purchased locally rs/maplins or electrical outletthe controller seems intact by the way.
Rob White
01-06-2013, 01:23 AM
.
I'm not sure if it helps but there is a dealership in Rugby
http://www.eurofrigo-uk.com/page3.htm
Regards
Rob
.
got yet another one of these ,this one has had the plug/wiring damaged that goes to the controller the plug is no longer on the cable,can this plug be purchased locally rs/maplins or electrical outletthe controller seems intact by the way.
We have just scrapped broken an as new ef. Loom is in the scrap at the moment.
Drop me a pm with your number.
Regards,
Djbe.
charlie patt
01-06-2013, 10:34 PM
if its a newer one its just a readout the controller is in the roofbox but im probable teaching you how to suck eggs there rip it out and fit a 974 or a cdc is our policy when ive had ones with a cut loom i have found they have shorted the controller out twice i got plugs of scrappers and the controller stayed dead so we just fit a sh panel of what we have lied around
clivemtk
04-06-2013, 07:59 PM
do you work for petit charlie
charlie patt
05-06-2013, 07:56 PM
no mate just run me own firm stuck down in devon with no wholesalers well nearest one is hr and half away so we have got rather good at fitting what we have in the van its useually cheaper and better in my book
cadwaladr
17-06-2013, 10:01 PM
if its a newer one its just a readout the controller is in the roofbox but im probable teaching you how to suck eggs there rip it out and fit a 974 or a cdc is our policy when ive had ones with a cut loom i have found they have shorted the controller out twice i got plugs of scrappers and the controller stayed dead so we just fit a sh panel of what we have lied around got a plug and cable from maplins hidi hi and because the cable to the unit is left with no plug on it anyone know where they connect to [which pins] thanks
clivemtk
18-06-2013, 07:44 PM
hi cad missed your post but will tell u pinout weds night
cadwaladr
18-06-2013, 11:36 PM
hi cad missed your post but will tell u pinout weds nightthanks clive top man!
The Welsh Wizard strikes again!
cadwaladr
21-06-2013, 03:08 AM
The Welsh Wizard strikes again!not yet he hasnt,come on clive!
clivemtk
24-06-2013, 07:28 PM
hi cad if u put plug into control 1=o 2=0 3=white 4=blue 5=yellow from left to right
cadwaladr
24-06-2013, 11:10 PM
many thanks clive ,will probably get to do it later this week.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.