Alarm code 19,25, ON SBIII

[neznam]

SBIII -30SR+ BN 914568
was in TK service couple of times for same problem
replaced oil pressure sensor , speed solenoid, checked ground etc ..
runs ok on continuous
when on cycle mode sometimes work ok ,but most of time works ok till when need to start again only click or make some fun sound on starter and show code

please if u have any advice ? thanks in advance

[gravy258]

does it then need a jump start to get it to go ?
sounds like the micro thinks the engine is running when its not, hence 19 and 25 ? is the rpm sensor OK ?

[neznam]

i only clear codes and starts with no problem without jump start
was having code 33 code to but after readjusting rpm is ok not showing 33 code again rpm is ok now i think ...? do not now exactly what is setting ? what u think for slow and high speed ?

if is micro can i bay new and just instal with no additional setup on micro or is job for real mechanic?

[gravy258]

rpm settings aren't that important to your situation.
is the starter motor OK ? so it just clicks, doesn't start and brings up 19 and 25 ?

the micro isn't cheap, you don't want to go there.

[neznam]

i found problem ....was bad wire going from + terminal to processor , TK SERVICE replace both battery terminals but no one look close wire was damaged. replaced battery termianl and fixed bad wire .....ALL OK NOW

TK SERVICE ADVISED TO REPLACE MAIN BOARD

THANKS