a83427498
19-03-2013, 09:29 PM
Hello. I’m looking for a replacement (low cost!) motor, as this one had water ingress and now has a leakage to earth. It is from an ASHP.
The shaft is 8mm diameter, although the screw thread and nut is smaller. Opposite outer mounting holes are 125mm apart. The inner mounting holes are 110mm apart.
Any suggestions appreciated. Even a similar motor that I can modify the existing mounting to fit would be fine.
Cheers!
1013310134
The shaft is 8mm diameter, although the screw thread and nut is smaller. Opposite outer mounting holes are 125mm apart. The inner mounting holes are 110mm apart.
Any suggestions appreciated. Even a similar motor that I can modify the existing mounting to fit would be fine.
Cheers!
1013310134