PDA

View Full Version : Unisab 3 unusual fault!







Grizzly
03-03-2013, 11:26 AM
Hi Guys.
Called out this weekend to a plant where one of the screws running on a Unisab 3 controller.
Shut down with the alarm status reading "The Oil Pump which has started to assist capacity slide un-load, has run for 30 seconds and in now stopped."
Comp reset fine (manual reset required).

Obviously I will talk to the Tech Guys at Sabroe Birmingham on Monday. I just wondered if any had had similar?
Slightly unusual this one!
Grizzly