PDA

View Full Version : problem with signal receiver



Greek_engineer
28-11-2012, 11:40 PM
Hello my friends.
I have a problem with an a/c and to be more specific the unit is not receiving the signal from the remote control.
I suspect that the problem lies with the electronic part on the circuit board that accepts the signal from the remote control.
How can I check if it is still on operation?
What measures should I do?
Can I use an other type of this electronic part?
Thanks in advance..

install monkey
28-11-2012, 11:47 PM
test the remote operates by pointing it at ur camera phone and pressing the buttons, you will see the infra red eye flash- as for testing the receiver,dont know but they should be relatively cheap

Greek_engineer
28-11-2012, 11:52 PM
where can I find one receiver on the web?

install monkey
28-11-2012, 11:59 PM
what make and model number?

Greek_engineer
29-11-2012, 07:06 AM
the a/c is not a famous one..probably it is made in china.
I do not know what the result would be in case I install an universal receiver.

Greek_engineer
29-11-2012, 06:01 PM
97719772
that's where the problem lies...the receiver...

Greek_engineer
29-11-2012, 06:05 PM
I do not how but after heating the connections ,on the board ,of the receiver,the latter re-activated...suspicious...

Daz man
07-12-2012, 11:55 PM
Strange, but glad you sorted it!

Daz man
07-12-2012, 11:56 PM
The make of the AC unit! It wasn't made by Gree was it?

Greek_engineer
08-12-2012, 05:12 PM
the make of the unit is "firstline".it was sold by a local super market called "carefour"

Amma
10-12-2012, 01:01 PM
Some units require a minimum remote sensor distance of 20 feet.Walk closer to the unit and try the command again.If there is any furniture in front of the unit or in front of the unit interface,move the furniture out of the way.If the remote control is close enough to and pointed at the unit,but still fails to operate,the batteries inside the remote control might be too weak to serve the appliance.I am sure you got the solution.Thanks.