BMS not picking up VSD fan

[Johan2]

Hi

I have replaced a blown vsd drive with a new drive. Now the bms is not picking up the fan. Fan is running,but the bms is showing that it is tripped. I know that it is a parameter setting fault. Can anyone just help me out please!! Don't know which parameter to change.

Old drive: LS SV-iG5A 18.5kW
New drive: Yaskawa A1000 18.5kW
Siemens BMS

Regards

Johan

[goshen]

Hi
are you using the relay outputs or the communication port?
try this :
http://www.yaskawa.com/site/products.nsf/products/Industrial%20AC%20Drives~A1000.html?openDocument&seq=1 (http://www.yaskawa.com/site/products.nsf/products/Industrial%20AC%20Drives~A1000.html?openDocument&seq=1)
best regards

[Johan2]

Thanks for the link Goshen. I am using the ouput relays.

[goshen]

HI
if that is the case, you should not have any problem configuring the outputs to do what you need .
good luck