Sardinha
17-08-2012, 04:12 PM
Hi all,
In the past we sell a lot of Outdoor units like RY71, 100 & 125 with indoor pcb's from duct tipe units FHYB. The idea was a practical system to provide DHW (domestic hot water) based on the control of the indoor unit and, of course, just disconnect the fan motor (no power lines or feedback circuit were necessary).
Now with the RZQS-G + FBQ-C a new issue takes over: Can't just dismiss the fan motor as previously, or the control will notice and give a error code [A6] or similar.
Does anyone know any kind of setting to be made via remocon just do tell the indoor init: "just forget the fan motor" ?
Thank You very much.
Best regards.
Sardinha.
In the past we sell a lot of Outdoor units like RY71, 100 & 125 with indoor pcb's from duct tipe units FHYB. The idea was a practical system to provide DHW (domestic hot water) based on the control of the indoor unit and, of course, just disconnect the fan motor (no power lines or feedback circuit were necessary).
Now with the RZQS-G + FBQ-C a new issue takes over: Can't just dismiss the fan motor as previously, or the control will notice and give a error code [A6] or similar.
Does anyone know any kind of setting to be made via remocon just do tell the indoor init: "just forget the fan motor" ?
Thank You very much.
Best regards.
Sardinha.