Andy AC
04-07-2012, 11:08 PM
Have got an ongoing problem with one of these ice makers. Machine is paddle motor/tilt pan type. System will run fine for a few cycles, then when after dropping ice and pan starts to come up, it will then stop the pan and start to fill with water. Problem is that because the pan is not in it's correct position, it just pours water all the time, flooding the machine.
Paddle motor, tray lifting motor and cam, and pcb have been replaced but still does the same after a few cycles.
Anybody got any other ideas, it's getting very boring.
Andy
Paddle motor, tray lifting motor and cam, and pcb have been replaced but still does the same after a few cycles.
Anybody got any other ideas, it's getting very boring.
Andy