mitsubishi kx 2

[MR T]

hello friend, i have problem with mitsubishi kx2 error code E34, how can i solve it

[install monkey]

• Abnormally low current (or no current) detected by [CT] on L3.
• Open phase detected at L3 (secondary side of contactor).
E34
-
Compressor current
• Abnormally low current (or no current) detected by [CT] on L3.
• Open phase detected at L3 (secondary side of contactor).
• Error on inverter board.

[MR T]

thanks ok now i need to replaced the inverter board

[iskan]

hi... good day to all.

i have 1 problem with kx2 system.. 1st error code e4. then i repair signal cable. i dont know how to reset system. then i power off system indoor and outdoor unit. after 20 minit, i power on system but error code e2 and e3 display at indoor remote control. any how to resolve this problem. indoor only 4 unit. outdoor single module only.