MrReds
11-03-2012, 09:41 PM
Hi there,
Hope you are fine.
I was analyzing the evaporators utilizing NH3 as refrigerant.
I have noticed that they have a tube diameter bigger than evaporators utilized for standard HFC refrigerants, ex 5/8” Vs ½”.
As consequence, the internal volume is bigger.
According to my point of view, the reasons are
- ammonia coolers are utilized for larger thermal loads than standard DX coolers. Since they are used in a flooded mode they are used in systems where mass flow is higher than DX ones.
- Ammonia liquid density is lower than other refrigerants density. Therefore it is needed an higher tube section.
Please, what is your point of view ? Do you agree with my interpretation ?
Many thanks
Hope you are fine.
I was analyzing the evaporators utilizing NH3 as refrigerant.
I have noticed that they have a tube diameter bigger than evaporators utilized for standard HFC refrigerants, ex 5/8” Vs ½”.
As consequence, the internal volume is bigger.
According to my point of view, the reasons are
- ammonia coolers are utilized for larger thermal loads than standard DX coolers. Since they are used in a flooded mode they are used in systems where mass flow is higher than DX ones.
- Ammonia liquid density is lower than other refrigerants density. Therefore it is needed an higher tube section.
Please, what is your point of view ? Do you agree with my interpretation ?
Many thanks