View Full Version : Frick screw Viking oil pumps
RANGER1
19-02-2012, 02:05 AM
Could anyone help me out on this one?
Viking oil pumps used on Frick screw compressors, would like to know correct part
numbers for each type of pump.
Viking AL, AK, AS, HL 4195 oil pumps.
Also are shaft seals in them anything special?
JCI & website can't tell you anything.
Thanks
PaulZ
19-02-2012, 11:52 PM
Hi Ranger
You can get all these bits from PC Feruglio in Melbourne. If you are replacing the seals make sure the carbon faces are Antimony loaded, this makes the carbon hard wearing.
I can send you the Viking part numbers for HL and AL 1495, not sure if I have the AK and AS info.
Paul
Magoo
20-02-2012, 02:22 AM
Hi Ranger.
Mr Google comes up with alot of info..
On your photo gallery, that screw rotor machine shop looks impressive. I must put that on the bucket list and call in some day.
magoo
RANGER1
20-02-2012, 04:58 AM
Hi Ranger.
Mr Google comes up with alot of info..
On your photo gallery, that screw rotor machine shop looks impressive. I must put that on the bucket list and call in some day.
magoo
You will have to come to our Taiwan headquarters to see that one.
At home we just use a file & 5" grinder, with near enough results.
RANGER1
20-02-2012, 05:02 AM
Hi Ranger
You can get all these bits from PC Feruglio in Melbourne. If you are replacing the seals make sure the carbon faces are Antimony loaded, this makes the carbon hard wearing.
I can send you the Viking part numbers for HL and AL 1495, not sure if I have the AK and AS info.
Paul
Thanks Paul, but I have a different reason for finding out.
Have known Peter a long time, also Kelair are agents if Peter does not have it.
We have been specifying antimony for more than 10 years, but Kelair we have to supply carbon & they fit for free.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.