Capacitor Size Required for 9,000 BTU

[Kompulsa]

Hello.

Does anyone know what capacitor size is required for a 9,000 BTU standard single phase compressor?

[chillerman2006]

Hi Kompulsa

all cap sizing differs, no good wild guessing

you will either need the original to match it with

the schematic for the compressor or the unit

or will need to ask supplier that stocks that compressor

or the manufacturer

R's chillerman

[paul_h]

Start cap, run cap, PSC cap?

[Kompulsa]

Start cap, run cap, PSC cap?

Run capacitor.

[monkey spanners]

Based on the supplied information i'd say, and i caution you its only a guess, one about 35mm round by 80mm long would do....






Always fit the same type and capacitance as fitted by the manufacturer, you can go higher on voltage but not lower. If all else fails, look at another unit by the same manufacturer and see whats on that one.

[chillerman2006]

Based on the supplied information i'd say, and i caution you its only a guess, one about 35mm round by 80mm long would do...





:D Haha, nice one mate

R's chillerman

[monkey spanners]

:D Haha, nice one mate

R's chillerman

I know people who used to size them by the dimensions! They had an oxygen reg for thier nitrogen bottle to so could only test to 14psi.....

[chillerman2006]

I know people who used to size them by the dimensions! They had an oxygen reg for thier nitrogen bottle to so could only test to 14psi.....

OMG, this industry has some real genius's and some from the other end of the scale, lmao

R's chillerman

[SeanB]

I had caps that were faulty ( would not pass acceptance test as ESR was off scale) so sent back to stores. Got them back again, they did a VISUAL check, and found them within specs. Sent back again with leads cut off...

[chemi-cool]

25mf 400volt capacitor will do the job.