PDA

View Full Version : Denco D12A


james10
20-09-2011, 10:19 AM
does anyone have a controls manual for the above unit it's a trend controller iq20
Thanks James
install monkey
20-09-2011, 09:25 PM
denco technical -aka rob woodworth rob.woodworth@geagroup.com
james10
20-09-2011, 09:31 PM
Cheers monkey, got passwords from him didn't want to pester him twice for manual aswell :)
install monkey
20-09-2011, 10:02 PM
he's the man-thats what he's paid for.
is that the controller before the milenium-with 4 password levels and a factory level up up up?
james10
20-09-2011, 10:42 PM
No, it's a trend controller just has up and down arrows and+ - symbols on it not sure about password levels I only wanted to alter the setpoint password was 1286 FYI
install monkey
20-09-2011, 10:49 PM
ta bud-trend generic access code 0403
james10
20-09-2011, 11:31 PM
Cheers mate I'll note that one down
Gideon Beddows
22-09-2011, 07:13 PM
There wont be a manual for the TREND products as each units' software is written specifically for that JOB.
Therefore a manual would be of no help.

As a side note. The Software is written by Geoff at the Factory. He left the Navy in December 1986. Hence the 1286 password :)
Push the UP arrow until the cursor is under the top line
Press the + until KNOBS is displayed
Press the down arrow once so that the cursor moves to the middle line of text
Press + until the correct KNOB is displayed (usually KNOB 3 is Temp Setpoint)
Press the down arrow until the cursor is under the Temp Setpoint
Press + or - until the desired temperature is required
and ta-da! Job done.
Sign here, tarra-a-bit!!
james10
22-09-2011, 07:41 PM
There wont be a manual for the TREND products as each units' software is written specifically for that JOB.
Therefore a manual would be of no help.

As a side note. The Software is written by Geoff at the Factory. He left the Navy in December 1986. Hence the 1286 password :)
Push the UP arrow until the cursor is under the top line
Press the + until KNOBS is displayed
Press the down arrow once so that the cursor moves to the middle line of text
Press + until the correct KNOB is displayed (usually KNOB 3 is Temp Setpoint)
Press the down arrow until the cursor is under the Temp Setpoint
Press + or - until the desired temperature is required
and ta-da! Job done.
Sign here, tarra-a-bit!!
thanks, i managed to sort it on the day with a bit of playing around ;), the password orign is interesting