sikeston34m
13-02-2011, 02:04 PM
Hi Everyone,
We recently went through a power outage, like so many times before. Only this time several fuses were blown, an MCC tripped out, and also this compressor developed problems.
None of the sensors were registering any values. Pressure pots nor temp probes were reporting.
Upon further inspection, I found the 5v, 12v power supply to be blown. It's internal fuse was not blown, but it wasn't putting out any voltage.
I thought, "Ok, we have a shorted sensor that must have taken out the power supply." Even though none of the sensors tested to have continuity to ground.
Once a new power supply was installed, I unplugged all the sensors from the board and powered it back up. Process of elimination all set to take place.
It immediately blew the new power supply. Once again, the new power supply's internal fuse is not blown.
So here I am, scratching my my head.
I have checked incoming power. All good there.
Does anyone have any insight as to what is wrong here?
This power supply feeds the mother board, the sensor board, along with 2 relay boards.
Any advice will be greatly appreciated. Thanks.
We recently went through a power outage, like so many times before. Only this time several fuses were blown, an MCC tripped out, and also this compressor developed problems.
None of the sensors were registering any values. Pressure pots nor temp probes were reporting.
Upon further inspection, I found the 5v, 12v power supply to be blown. It's internal fuse was not blown, but it wasn't putting out any voltage.
I thought, "Ok, we have a shorted sensor that must have taken out the power supply." Even though none of the sensors tested to have continuity to ground.
Once a new power supply was installed, I unplugged all the sensors from the board and powered it back up. Process of elimination all set to take place.
It immediately blew the new power supply. Once again, the new power supply's internal fuse is not blown.
So here I am, scratching my my head.
I have checked incoming power. All good there.
Does anyone have any insight as to what is wrong here?
This power supply feeds the mother board, the sensor board, along with 2 relay boards.
Any advice will be greatly appreciated. Thanks.