Cool Force
22-01-2011, 02:38 PM
Hi all, how do I bend the pipes attached to the inside unit of a midwall split without cutting off the nuts on the end.
The springs that come attached don't cover the entire length of the pipes, so obviously the end part of the pipe can't be bent, or it will kink. The only way I can think of is to cut that end(thread for the flare nut) off and use a spring bender, then weld the pipes together..
Is there another way to bend them, so I can avoid the cutting and welding method?
The springs that come attached don't cover the entire length of the pipes, so obviously the end part of the pipe can't be bent, or it will kink. The only way I can think of is to cut that end(thread for the flare nut) off and use a spring bender, then weld the pipes together..
Is there another way to bend them, so I can avoid the cutting and welding method?