104ord
17-01-2011, 09:59 AM
hi all im new to the forum and if im posting in the wrong section im sorry in advance..
the problem is that ive aquired a jiangsu banshen ice maker.. im struggling to find information and parts for this unit.
the unit was short of gas and had a leak at the end of the capillary, i fixed the leak and gased it up it ran perfect for 2 cycles produced good solid clear ice no worries but on its third attemp the tray just continued to drop and rise time after time.
i switched the unit off and turned it back on again and now it only does this..
-ice tray drops and then rises
-the water fills to the correct level
-the compressor kicks in and runs great but as soon as this happens the agitators start turning and the tray drops before the ice can form.
-the tray will rise back up and continue to rise and fall rise and fall about 6 times and then throws on a fault light..
ive never done any thing with ice machines before i was hoping to learn with this one but im out of ideas.
any thoughts will be much appreciated.
the problem is that ive aquired a jiangsu banshen ice maker.. im struggling to find information and parts for this unit.
the unit was short of gas and had a leak at the end of the capillary, i fixed the leak and gased it up it ran perfect for 2 cycles produced good solid clear ice no worries but on its third attemp the tray just continued to drop and rise time after time.
i switched the unit off and turned it back on again and now it only does this..
-ice tray drops and then rises
-the water fills to the correct level
-the compressor kicks in and runs great but as soon as this happens the agitators start turning and the tray drops before the ice can form.
-the tray will rise back up and continue to rise and fall rise and fall about 6 times and then throws on a fault light..
ive never done any thing with ice machines before i was hoping to learn with this one but im out of ideas.
any thoughts will be much appreciated.