petter78
09-12-2010, 07:03 PM
Hi all,
I am having a problem with a GSC OP panel based on the Siemens S7-300 and C7-633.
The problem is that once in a while there is a power failure which once in a while results in an error:
Recovered after a power failure (just about).
The error does not show every time, but often enough for the customer wanting to have it fixed.
I have not been able to produce the error.
Does anybody have an idea about what is causing this behavior?
Regards,
Peter
I am having a problem with a GSC OP panel based on the Siemens S7-300 and C7-633.
The problem is that once in a while there is a power failure which once in a while results in an error:
Recovered after a power failure (just about).
The error does not show every time, but often enough for the customer wanting to have it fixed.
I have not been able to produce the error.
Does anybody have an idea about what is causing this behavior?
Regards,
Peter