Thermo King alarm code 40

[sneaquie]

Can anyone please tell me what the problem is with a TK SBIII SR+ that has a code 40 and how to fix it? I realize it's a high speed circuit but I'm hoping it's not complicated and going to cost me an arm and a leg!!:cool:

[clivemtk]

have you tried the soleniod is not stuck in or out and is fuse 9 ok on relay board

[sneaquie]

Thanks for the tip, Clivemtk. It was the rod in the solenoid had come loose. :D

[abbsnowman]

Sneaquie, if your ever on the left coast, come see me for a quick crash course!

[DaButcher]

Thanks for the tip, Clivemtk. It was the rod in the solenoid had come loose. :D

Mechanics wire does wonders on most high speed alarms! :cool:

[ruzgar78]

hi my frends Thermoking Alarm code A14
how is my clear codeA14
CAN YOU HELP ME PLS
EVERYTIME A14
WHERE IS THE PROBLEM

[abbsnowman]

Check refrigerant level and coil sensor.

[ruzgar78]

Thank you for the reply but when I inserted a new indicator panel, no problem, but the problem would go var.Neyseki a problem with this device. Do you have someone with experience, he became a member of the form. Thank you very much.
I'm looking at these devices, electronic hardware and electronics engineering or even the real profession is a different system for diesel tasarladım.Türkiye extensively used as refrigerants, you just say you should not do to me what I'm planning to motor unit. We promote and send a picture of sismtem short.
write to me if you have a msn address

my email address
ali_ruzgar78@hotmail.com

[abbsnowman]

Ummm...... no idea what your saying? :confused:

[moggy66]

Ummm...... no idea what your saying? :confused:
Try drinking a few beers then re read...might make abit more sense:D:D

T

[abbsnowman]

Ok, I'm a couple Makers Mark whiskey's in now and it still makes no sense.....
Cheers Moggy, always good to see ya here!

[joelsantander]

re: A14..if not the coil sensor, try checking the damper might not closing during defrost...