Paul-M
19-10-2010, 05:45 PM
Could anyone offer me some advice please?
I'm about to begin an installation where the plant room containing the compressor receiver set is on a first floor approximately 4m above the condenser situated outside at ground level. Should I be allowing for any special considerations with the pipe sizing and the actual design of the discharge and liquid return pipework because of their relative positions, maybe keeping the liquid return velocity on the high side because of the 4m lift?
Any advice received would be most welcome :)
I'm about to begin an installation where the plant room containing the compressor receiver set is on a first floor approximately 4m above the condenser situated outside at ground level. Should I be allowing for any special considerations with the pipe sizing and the actual design of the discharge and liquid return pipework because of their relative positions, maybe keeping the liquid return velocity on the high side because of the 4m lift?
Any advice received would be most welcome :)