View Full Version : Program for PC
Flashy
02-10-2010, 04:21 PM
I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .
Brian_UK
02-10-2010, 11:16 PM
Download CoolPack.
sammycclass
03-10-2010, 06:11 AM
[quote=sammycclass;205263]Hello
:off topic:
I have Thermo King with a RD II shut down problem.
Don’t know what to do any more I did check some wires look ok. Check oil and water ok
Starts some times shuts down ride away and sometimes runs for a few minutes when I adjust the rpm screw to high rpm is ok so I get the fallowing codes 71 77 61 sometimes code 74 as well please help
Thank you
Peter_1
03-10-2010, 08:16 AM
Or Solkane from Solvay
For Sammycslass, nobody will answer you post if you don't do the efforts to post it in the right section
clivemtk
03-10-2010, 09:48 AM
code61 =low battery voltage try fitting a slave battery and run on test
Flashy
03-10-2010, 11:02 AM
Download CoolPack.
Thanks for the fast reply
sammycclass
06-10-2010, 07:24 AM
I did check all battery connection and power and ground all ok will start and turn off so I check contacts all ok check diesel in to fuel filter all ok check oil and water all ok removed circuit board cleaned all contacts with contact cleaner because I have seen some light mildew on the circuit board removed & reinstalled back now control panel in cab will not light up if I turn on black switch on position it will turn on and off buy itself so don’t know what to check any more please help.
Thank you
Lodiev
04-11-2010, 03:39 PM
I have a pocket refrigeration calculator from DUPONT witch can do all T/P conversions in a split second for all common used gases. I got it from a local refrigeration spares company that cells DUPONT gases. So try your local gas supplier.:eek:Keep on Topic PLZ
mcjo tech
16-11-2010, 10:52 PM
I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .
www.exactchargehvac.com (http://www.exactchargehvac.com)
Click on ExactCharge Calculator on left hand side.
Click on Conv key for SI Mode.
Instructions are also available.
mcjo tech
16-11-2010, 10:55 PM
I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .
www.exactchargehvac.com (http://www.exactchargehvac.com)
Click on ExactCharge Calculator Icon on left hand side.
Click on Conv key to convert to SI Mode.
Instructions are also available.
Free.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.