Carbo cooler product temperature control

[telbertirish]

Hi
This is my 1st post and I'm hoping to resolve an issue with a carbo cooler.
I was wondering if anyone has ever automated the back pressure valve modulation to achieve a desired temp.
This would shorten setup times for the varying products that is produced via the carbo cooler by inputting a desired temperature and have a controller modulate the BPRV

Regards

[telbertirish]

Got a solution.

Thanks

[RANGER1]

We have controlled product tempreture best with water pre-cooler for varying seasonal water temps .

Used plate heat exchanger for this .

You could use auto back pressure/tempreture regulator but you would not go much below -3 C or risk icing of plate .

Hope this helps .