Refco Gauges BM2-3-DS-CLIM

[Jobseeker]

Can anybody tell me if the Refco BM2-3-DS-CLIM gauges actually have scales on them for R22 R410A & R407C and can they be used for any other types of gas ?

I understand that they come with 1/4 SAE and 1/2 - 20 UNF, so all bases are covered.

Has anybody experience of using this Refco gauge and if so what are they like ?

Any advice on any other gauges on the market that cover R410A and other gases would be helpful.

Thank's

[avico]

We're REFCO Exclusive Distributor in Vietnam


http://cA7.upanh.com/12.400.16632039.HUK0/IMG_0074.jpg
http://cA5.upanh.com/12.400.16632049.OOP0/IMG_0071.jpg
http://cA5.upanh.com/12.400.16632057.OOP0/IMG_0072.jpg
http://cA6.upanh.com/12.401.16632066.CPH0/IMG_0073.jpg
http://cA5.upanh.com/12.401.16632077.DHU0/280820101110.jpg

[nike123]

Any gas pressure could be measured with this gauges but you need P/T chart for other gases.

I have them and they are OK for everyday use in AC business.
They are not much precise (small diameter, low resolution) for accurate calculation of superheat and subcooling. That is much easier with good digital gauges (Testo, Digicool).

[kiwireeferman]

Manifold is ok, but I dont think you would be that thrilled with the gauges.
I think you would be better off with the Refco or Yellow Jacket 1% type.

[Jobseeker]

Dear kiwireeferman, can you be a little bit more precise please ?
I am a little confused mt friend.
Model Numbers would be most helpfull.

[nike123]

http://www.refco.ch/en/products/gauges.php

Check R5 and R7 series.

[Jobseeker]

Thanks Everyone !