PDA

View Full Version : DX coil software



abbasi
20-05-2005, 12:59 PM
HI

can anybody give me DX coil(evaporator) software :confused:

Danfoss
21-05-2005, 05:54 AM
try at http://www.guentner-online.de/, then go to service and then downloads.
is the full selection software.

frank
21-05-2005, 10:36 AM
would that be the

herstellererklaerung&rubnum

or the

freistellungsbescheinigung&rubnum :D

Danfoss
21-05-2005, 10:46 AM
I guess the english version is more friendly... :)

abbasi
21-05-2005, 11:33 AM
Thanks maite


can u tell me which fin type to usein software coz we have plain fins of aluminum i am bit confused by which fin type to use
i just select for 12 FPI + more coz of machining constraints

the method i used to calculate DX coil was for 15 FPI


rows=............. .............. Total capacity
...................... 440Xface areaX(Critical temp-Evap. Temp.)

or say

rows = capacity divided by
{440Xface areaX(Critical temp-Evap.}

for dry coil

rows= capacity divided by {K X A X METD}

Danfoss
21-05-2005, 11:59 AM
I don't understand.
The software gives you automatically the material of the coil and of the fins, the dimmensions, the number of rows, the pressure drop etc...

Peter_1
21-05-2005, 04:36 PM
or www.lemmens.com and then software section.

abbasi
23-05-2005, 04:47 AM
HI Pete


the lemmen company site asks for username and
password :confused:

Also its about AHU


Regards

Ali