coolmat
20-07-2010, 04:50 AM
Hello all,
I'm new to this forum and if I'm here is because I have need your advice!
So thanks in advance for your time.
I'm setting up for a computer room, 2 Chillers HPC-S which are redundant.
Both have an Hiromatic SCM and I also have an iCom module.
I need to set the system so it all works together and
Check out hte attached pictures for better comprehension.
The Icom as an ethernet cable as the hiromatic have.
Should this cable go to the first Hiro and from there cascade the 2nd one?
I also realized that there is a Temp and Humidity sensor inside the electrical panel of both chillers.
What is it for? These chillers are water chillers and as far as I know the Tē reading is done on the water.
Any help is greatly welcome.
Thanks in advance again.
Cheers,
MAT
I'm new to this forum and if I'm here is because I have need your advice!
So thanks in advance for your time.
I'm setting up for a computer room, 2 Chillers HPC-S which are redundant.
Both have an Hiromatic SCM and I also have an iCom module.
I need to set the system so it all works together and
Check out hte attached pictures for better comprehension.
The Icom as an ethernet cable as the hiromatic have.
Should this cable go to the first Hiro and from there cascade the 2nd one?
I also realized that there is a Temp and Humidity sensor inside the electrical panel of both chillers.
What is it for? These chillers are water chillers and as far as I know the Tē reading is done on the water.
Any help is greatly welcome.
Thanks in advance again.
Cheers,
MAT