TECH TIM
17-05-2010, 09:44 PM
Hi All,
It's been a while since i've been on here, i just want some advice on this daiken as i dont see many of em.... i have a ftxd 71 juea approx 10 yrs, the indoor unit just shut down and flashing constant, i reset power and ran found outdoor came on then off within 10 secs, it had a fault indicator on out door pcb red led 3 on and green led flash, the chart says pcb output too high, i checked the compressor windings and they are 2 ohms each (there is 4 windings?), the compressor when attempting to start pulls 13.5 amps, is 13.5 amps excessive? when i disconnected comp from pcb the outdoor fan ran for a god 4-5 mins before the unit shut down due to another fault picked up by pcb saying temp sensor not reading, i assume this fault is due to comp not running? it appears to be compressor to me but some advice would be greatly appreciated cheer guys take care......:)
It's been a while since i've been on here, i just want some advice on this daiken as i dont see many of em.... i have a ftxd 71 juea approx 10 yrs, the indoor unit just shut down and flashing constant, i reset power and ran found outdoor came on then off within 10 secs, it had a fault indicator on out door pcb red led 3 on and green led flash, the chart says pcb output too high, i checked the compressor windings and they are 2 ohms each (there is 4 windings?), the compressor when attempting to start pulls 13.5 amps, is 13.5 amps excessive? when i disconnected comp from pcb the outdoor fan ran for a god 4-5 mins before the unit shut down due to another fault picked up by pcb saying temp sensor not reading, i assume this fault is due to comp not running? it appears to be compressor to me but some advice would be greatly appreciated cheer guys take care......:)