frederik79
27-02-2010, 04:13 PM
hi ,
The picture i included is one of a heat exchanger,the tube is the exit liquid pipe
from a freezing application (hope this is the right place to post this)
It struggled for a long time with low pressure issues.
i think this fault is due to bad brasing (20%)
instead of 80 %
have you guys ever seen this kinda thing before ??
and what do you think :cool:
thank you
The picture i included is one of a heat exchanger,the tube is the exit liquid pipe
from a freezing application (hope this is the right place to post this)
It struggled for a long time with low pressure issues.
i think this fault is due to bad brasing (20%)
instead of 80 %
have you guys ever seen this kinda thing before ??
and what do you think :cool:
thank you