glenn1340
07-01-2010, 07:52 PM
Hi guys,
We`ve got small job on that needs a bit of info on a HGBP. It`s a Alco but has no info on it. The parts buyer has had no luck describing it to the equipment manufacturer, Alco, HRP, Climate Center etc.
So, here`s my question: I know capacity selection is critical for a TEV but is it the same for a hot gas valve? as long as the inlet/outlet connections are identical I can`t see a problem. Therefore could we fit a valve with the same connections. After all as far as I`m aware its sole purpose is to regulate the evaporator pressure.
Thanks in advance guys,
Glenn
We`ve got small job on that needs a bit of info on a HGBP. It`s a Alco but has no info on it. The parts buyer has had no luck describing it to the equipment manufacturer, Alco, HRP, Climate Center etc.
So, here`s my question: I know capacity selection is critical for a TEV but is it the same for a hot gas valve? as long as the inlet/outlet connections are identical I can`t see a problem. Therefore could we fit a valve with the same connections. After all as far as I`m aware its sole purpose is to regulate the evaporator pressure.
Thanks in advance guys,
Glenn