View Full Version : M-NET Maint Tool Interlocking Password
cphealy
03-01-2010, 07:25 PM
I have a Mitsubishi DIDO interface that I want to configure the interlock settings for.
I have the CMS-MNG and Windows Maint Tool to configure it with, but cannot yet set the Interlock settings without a password.
Does anyone know the password for allowing control of interlock settings?
Thermatech
04-01-2010, 09:50 AM
I have been working with Mitsubishi Electric Mnet monitor tool for about 13 years but not exactly sure what you are trying to do.
Normally you get the CMS-MNF interface & a software disk.
You load the software program onto you laptop. Connect the interface to system & start monitoring.
There has never been any password setting needed.
Perhaps Mitsubishi have introduced something new which needs a password.
So what is the interlock settings for ?
Why do the interlock settings need to be configured ?
jmostrebu
02-02-2010, 03:04 PM
As to place sw of cms-mnf-b to connect with the program Maintanance Tools in local form
Thanks
jmostrebu
05-02-2010, 03:22 PM
Problems to connect cms-mnf-b remotely, some manual to connect it and that works
I connect remotely with moden Usb robotics and in the converter cms-mnf-b this connected through mc35 siemens yet the cables that correspond to him according to connection manual, makes the call but it hangs to me
Thanks
jimibdn
10-02-2010, 01:55 PM
You have a 4.XX version , no?
That password is for comissioning DIDO´s and need a oficcial service net to do that, at least in spain.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.