dmytrok
11-11-2009, 12:53 AM
How do you do.
Can who that will prompt please on controller Termoguard Mp-D (is installed on reefer container TK CSR40-66).
Such fault - after power-up passes the test of the indicator whereupon for second appears "PHASE CHECK".
But hereinafter gives the inscription "TEST2 PASS"
but when striking on alarm list gives the mistake "ALM 1 5 35".
More no buttons act, program TK Smart Sponge is not identified. Also no exchange Rx/Tx data with MP-D output modul.
Can is required change flash? (was a version 11.60) What program?
Thank you.
Can who that will prompt please on controller Termoguard Mp-D (is installed on reefer container TK CSR40-66).
Such fault - after power-up passes the test of the indicator whereupon for second appears "PHASE CHECK".
But hereinafter gives the inscription "TEST2 PASS"
but when striking on alarm list gives the mistake "ALM 1 5 35".
More no buttons act, program TK Smart Sponge is not identified. Also no exchange Rx/Tx data with MP-D output modul.
Can is required change flash? (was a version 11.60) What program?
Thank you.