sork
19-08-2009, 07:47 PM
hi guys
i am working on a multi city mitsubishi, unit 6 is not working, the controller does not show any error , temp is 27 c set at 19c but unit not cooling.
i set the group on cooling - press enter then at the bottom( function area) it shows
mon ph col m mr
i press mon to blink then enter
address apears saying press the switch you want to operate.
secondly the setting at the bottom is blinking , is that normal?:off topic:
i am working on a multi city mitsubishi, unit 6 is not working, the controller does not show any error , temp is 27 c set at 19c but unit not cooling.
i set the group on cooling - press enter then at the bottom( function area) it shows
mon ph col m mr
i press mon to blink then enter
address apears saying press the switch you want to operate.
secondly the setting at the bottom is blinking , is that normal?:off topic: