View Full Version : magnetic bearings
We have at present stal s73 screws installed at the office complex where I work as a refrigeration tech. They are over 30 years old and are to be replaced in the winter with york centrifs. The yorks have magnetic bearings wich I have heared about but hav'nt come across yet. Out of interest has any one had any experience with them. regards dill.
chemi-cool
26-06-2004, 05:43 PM
Hi Dill.
Here is some information on the subject,
http://www.skf.com/portal/skf_rev/
http://www.synchrony.com/magbear.htm
Chemi
cheers chemi, I will go there when I get back from the chip shop.
Blueboy
26-06-2004, 09:28 PM
I new nothing about Mag bearings. I do now! :) Many thanks Chemi.
s1030
13-05-2011, 09:01 AM
I had some questions about them .
1) how are the controls for the magnetic bearing.
2) have they been tested to work in specialized environments like offshore / ships etc.
3) how good are the bearings from maintainability and reliability point of view?
Thanx in advance
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.