View Full Version : mcs controller
goshen
05-04-2009, 08:34 PM
hi i have a unit with 2 screws ( hannbell ) works ok but control screen connected to mcs magnum controlboard displays messages like lost a\d converter or lost display i tried evrything including replacing board and display with no results the unit keeps running ok but customer keeps complaining any advice?????????????????????:D
vinod
14-04-2009, 02:05 PM
Hi,
which mcs(micro control system) control is this any model no,name avilable or check www.mcscontrols.com
goshen
24-04-2009, 02:49 PM
it is the mcs magnum with a lcd display connected to it
vinod
24-04-2009, 06:06 PM
hi,
disconnect all outputs from the controller one by one then see the display. i think any senosor or transaducer is short.
absrbrtek
26-04-2009, 02:55 AM
Call MCS, their tech support is very good IMO.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.