docgreen9
13-03-2009, 07:13 PM
Hi guys hope this is the place to put this question. I have a CS60 Scotsman that is like new. It was installed used a couple times and set up since dry.
Upon initial startup I found the water valve stuck open so replaced that. Now it'll start, fill, pump, spray but the water doesn't get cold at all and only the first 9" of the evap is ice'n up. The rest of it is cool at best. Looks kind of weird. I have no gauges. High side is hot coming out of compressor, low side is ice'n up going into the evap other than that I'm stuck.
Any help would be appreciated.
Thanks.
Upon initial startup I found the water valve stuck open so replaced that. Now it'll start, fill, pump, spray but the water doesn't get cold at all and only the first 9" of the evap is ice'n up. The rest of it is cool at best. Looks kind of weird. I have no gauges. High side is hot coming out of compressor, low side is ice'n up going into the evap other than that I'm stuck.
Any help would be appreciated.
Thanks.