PDA

View Full Version : Tecumseh Compressor



airefresco
10-03-2009, 10:46 PM
Does anybody have any info on a TPG1410YXC compressor. Itīs not listed on Tecumsehīs website site, in any catalogue that I have or even on Google. I have to replace one of these compressors and Maytag sent out a replacement an Embraco EGY100HLC, but Iīm not sure if itīs the right replacement. It is physically bigger and I donīt think it will fit anyway.

Any info greatly appreciated.

paul..

doormaster2008
11-03-2009, 12:13 AM
its not a tpa1410 is it.that is a 1/4hp on r134a

airefresco
11-03-2009, 09:27 AM
Iīm pretty sure it was TPG. Iīm going to check again to make sure because I canīt find anything that starts TPG.

nike123
11-03-2009, 09:39 AM
Iīm pretty sure it was TPG. Iīm going to check again to make sure because I canīt find anything that starts TPG.

http://www.totaline.com.ar/site/uploads/file-2006524104535-0.pdf
It is PTCSCR R134A 8,37cm^3/rev low temperature normal torque, nominal capacity of 1000btu.

It looks like you have good replacement model.

If it is TPA then TPA1410 is equal to the Danfoss NF11X!

airefresco
12-03-2009, 12:28 AM
Thanks Nike, how did you find that? The model is definitely the number I quoted in the original post, I checked it today. It looks like the new one is a good match.

nike123
12-03-2009, 06:58 AM
Thanks Nike, how did you find that? The model is definitely the number I quoted in the original post, I checked it today. It looks like the new one is a good match.


http://www.refrigeration-engineer.com/forums/showpost.php?p=86065&postcount=2 ;)