PDA

View Full Version : Frick Plus Panel



J.D
05-02-2009, 04:01 PM
Hi Guys

I'm working with an old Frick plus panel with a Rev C board in it, operating an RWB II 222. I've heard that you can reset the bios on these boards by jumping across one pin from U4 to a pin on U5 ( Eproms ). Does anyone know which pins to jump out? I would hate to get it wrong and burn out the chips.

Thanks
J.D

nh3wizard
05-02-2009, 04:04 PM
I have never heard of this; but I am sure there is someone on RE who can give you a definite answer.

josef
05-02-2009, 04:37 PM
Microprocessor EPROM memory I/C chips are located inside
the microprocessor console on the SBC board. A special
tool is required to remove these chips to lessen the
chance of damaging them (See Troubleshooting The
Microprocessor). The procedure to replace EPROM memory
chips is outlined below:
1. Shut off control power.
2. Remove the microprocessor console cover.
3. Using a chip extraction tool, remove the old EPROM chips
from the SBC board. Pay particular attention to the orientation
of the notch on the end of the chip; then install new chip
with the notch in the same position. NOTE: The chip labeled
4 must be inserted into socket U4 and the chip
labeled 5 must be inserted into socket U5.

GHAZ
05-02-2009, 06:44 PM
Hello jd send me your email address and i post you the litrature