PDA

View Full Version : Hitachi FSN1 3 pipe vrf r410a







s.wallbank
15-12-2008, 04:43 PM
Hi all,

does anyone out there have the technical manual for an hitachi ras 10 fsn1e 3 pipe vrf. I need to change the discharge pressure transducer tomorrow. I have found the problem with the system just need to know if there is a schrader valve fitted at the sensor and if I can simply unscrew it and replace without spending hours on gas recovery etc. Any help is much appreciated.

Thermatech
15-12-2008, 05:01 PM
The last Hitachi one I changed was on a schreader but they tend to change the specification from time to time so you can never be absolutely sure.

The safety HP switch is brazed in as I recall. But the pressure sensors are on schreader so can be unscrewed & replaced easily.

s.wallbank
15-12-2008, 05:13 PM
Thanks a lot. Was there last week I remember seeing the hp switches brazed on as you say but was in a rush to go after finding the problem so did not take a lot of notice how it was attached. Got the new sensor now but wasn`t looking forward to pulling the gas out cause I`ve got the slowest recovery machine in the world. Thanks again.

superswill
15-12-2008, 08:18 PM
Hi all,

does anyone out there have the technical manual for an hitachi ras 10 fsn1e 3 pipe vrf. I need to change the discharge pressure transducer tomorrow. I have found the problem with the system just need to know if there is a schrader valve fitted at the sensor and if I can simply unscrew it and replace without spending hours on gas recovery etc. Any help is much appreciated.


log onto

http://www.hitachiaircon.com/argws/loginAction.do?action=loginForward

register at

http://www.hitachiaircon.com/argws/UserRegistrationAction.do?method=RegisterUser