PDA

View Full Version : Support for the wall panels - cold store with no locks







smpsmp45
10-07-2008, 05:28 AM
Typically for the cold store wall panels with no locks - Continuous line- wall panel supports are necessary. We too have been providing the same. But I was looking for technical explanation on this. What should be the height of the wall panels where in this becomes necessary? What distances on height reference? All manufacturers have their own methodology & calculations on this & obviously that is confusing as usual.

smpsmp45
10-07-2008, 09:06 AM
One file is attached with the issue being highlighted. THe phase One cold store if provided with the wall panel supports, the second phase installation is problematic.