View Full Version : Mitsubishi controls
pabloabbs
08-04-2008, 08:22 PM
can anyone shed some light on fitting interfaces to mitsi mr slims. I have a wallmount with wireless remote want to fit run/fault indication what should I use and how is it fitted
nh3wizard
08-04-2008, 08:28 PM
I don't know the answer to your question, but welcome to RE, I'm sure someone here knows the answer to your question.
Thermatech
08-04-2008, 11:20 PM
Depends which model, but the old 5 wire addaptor should still good for current R410a models.
UK part No PAC-SA88HA-EP cost about £10.00
It plugs into the indoor unit circuit board & can be wired up for remote on/off control & remote run/fault indication. You might need a 12v d/c relay & a 12v d/c power supply depending on exactly what you are trying to do.
If the site has City Multi systems & G50 or MJ103 or Mj310e central control then you could push out the boat & fit M-net interface & control from the central controller. Much better but cost for the interface is about £110.00.
narkom
09-04-2008, 09:18 PM
UK part No PAC-SA88HA-EP cost about £10.00
It plugs into the indoor unit circuit board & can be wired up for remote on/off control & remote run/fault indication. You might need a 12v d/c relay & a 12v d/c power supply depending on exactly what you are trying to do.
I guess this leaflet will be useful
http://www.mitsubishi-electric-aircon.de/pdf/Controller_leaflet_GB.pdf
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.